Rebordear Suministros:
A - 3 mm Swarovski Crystal Bicone # AB 5301 x 4 unidades
B - 4mm Swarovski Jet Bicone # 5301 x 2 uds
C - 8mm Mariposa # 5754 Swarovski Jet x 2 uds

Otros Suministros:
D - 3cm Headpin con pelota x 2 uds
E - 2.5cm Eyepin x 2 uds
F - Ear Wire pares x 1

Step 1: Slide 1 A, 1 C & 1 A onto the headpin.

Step 2: Use Chain Nose Pliers, bend a right agle as shown in the picture above. Bend slowly, don’t break your beads ya?

Step 3: Cut the excess headpin at position about 8mm measured from the hole of A.

 

Step 4: Use Round Nose Pliers to make a simple loop.

Step 5: Take an eyepin, slide 1 B onto it.

Step 6: Repeat step 3.

Step 7: Repeat step 4.

Step 8: Use Chain Nose Pliers to open the loop in upward position.

Step 9: Attach the beaded butterfly link onto the loop that you have opened in previous step. Close the loop in the reverse direction.